הצג עוד

Video screenshots

  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 1
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 2
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 3
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 4
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 5
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 6
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 7
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 8
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 9
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 10
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 11
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 12
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 13
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 14
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 15
  • inserting the straw of the gas cylinder into the gland for a smooth erection. snapshot 16

With the oxygen gas cylinder I implanted the straw in the glade and then there were many extreme cumshots.

פורסם על ידי Excitado28

  • 0
  • 00:00
תגובות
4
יש או כדי להגיב
Holzofen1960 לפני 5 חודשים
DRECK
השב
richard132
richard132 לפני 8 חודשים
Hallo was hast du da für Gas genommen ? Lg Richard 
השב
Fkkficken
Fkkficken לפני 8 חודשים
Langweilig. Was soll das
השב
SanDiegoChangeling לפני 1 שנה
Yayyy!!! You tried! Thank you. Melt the end with a lighter slightly to round off the sharp edge of that plastic. Also, you may want to cut the last 1/4" off the end first because I think the second graduation up will fit you just fine, perfectly in fact. That first stem is too long for now. Just be sure to melt the edges slightly with a lighter, rounding the edges off while it's still maliable with your fingers. Let it cool then send it in a little slowly going about half an inch. Tape it there if you need, which will free that hand to use elsewhere. Good job bro. Hot to finally see this . I knew you could do it. HOTAF
השב